COASTVAX - 30 KNOT STRUCTURAL WING LOAD

 

Please use our A-Z to navigate this site or return HOME

 

 

 

Filtration head water treatment Design Copyright 2019

 

 

DESIGN DRAFT - The filtration module, cargo hold and offloading mechanism is shown in red in outline form in the above diagram. The system consists of several integrated components, incorporating motors, pumps, hydraulics, electronics and computer programs - all to be powered by energy from nature - to avoid creating greenhouse gas emissions. You can see from the level of integration that such a system would not lend itself to a bolt-on item for existing vessels. The vessel has to be custom designed and built.

 

 

 

 

 

STRESSING CALCULATIONS

 

Scaling Up: Mechanical Stress Considerations for the Wings

If and as we transition from the 1:20 Elizabeth Swann model to the basic CoastVax (full) scale, the primary engineering focus points for the drive shafts and offset gears will be:

Torsional Wind-Shear Loads: Wind flowing over the raised 8-panel tracking wings will create a rolling moment arm around the central drive shafts. Using dual offset driven shafts (proven on the Swann model) distributes this torque evenly across the deck framing rather than loading a single central pivot.

Emergency Storm-Furl Interlock: High-speed anemometer triggers must be integrated into the NMEA 2000 control bus to automatically retract and fold the wings flat over the central deck whenever apparent wind speeds exceed 25 knots.

 

 

 

 

Coastal and river skimmer workboat solar powered

 

 

 

COASTAL CLEANER SIDE VIEW V1 - This is a draft design for a coastal/river experimental rig based on the SeaVax concept from March 2019. Unlike SeaVax, this low budget development boat was to be built of steel, not aluminium, to keep the up front costs down, though long-term use would favour aluminium alloys. As to economics, who might pay for the operations of such a vessel locally remains to be answered. Unlike a dustcart that collects household waste, there is no immediately obvious health hazard from not cleaning or monitoring the oceans, rather it is out of sight, toxic, cumulative and just as deadly. We are no longer promoting wind power, the state having shown no interest in that method of propulsion. It will need someone with deeper pockets and more influence, to carry that particular torch. The good news being, that the craft is far less complicated design wise.

 

 

 

 

 

 

         

 

 

 

DRAFT COASTAL DESIGN - These diagrams show a single 1.5kW wind turbine mast, an experiment that was planned for 2020 funding dependent - that never materialised. This version uses 36 solar panels to give 6.9kW (9.25hp) per hour energy harvesting in sunlight. It is worth noting that a small craft like this offers only one eighth the efficiency of the full size SeaVax machines. The solar panels were of the cheaper variety to contain costs, but since then, prices have tumbled.

 

 

 

 

 



Structural, wind-load, and torsional stress analysis for the CoastVax 8-panel solar tracking wing operating in coastal marine environments.

1. Environmental & Geometry Inputs

• Wind Speed (V): 30 knots = 15.43m/s (Beaufort 7 - Near Gale).
• Air Density (rho): 1.225 kg/m3 (sea level, 15C).
• Dynamic Wind Pressure (q):

 

 

 

 

• Safety & Gust Factor (Cg): 1.30 (accounting for transient 30-knot gusts and marine boundary layer turbulence).
• Panel Wing Dimensions (8 panels):

 

- Individual panel size: 1.76m x 1.13m (450W rigid marine module).

- Total wing surface area (A): 8 x 2.0m2 = 16.0m2.
- Wing span along drive shaft (L): 8 x 1.15m approx 9.2m.
- Moment arm from drive shaft axis to panel centroid (r): 0.88.

 

 

2. Aerodynamic Force & Bending Calculations

Wind pressure varies significantly based on wing tilt angle relative to the horizon (theta):

 

 

 

 

 


Peak Normal Force (F_perp) at Worst-Case 60° Tracking Angle:

 

 

Fperp = q x Cg x Cd x A = 145.8 x 1.30 x 1.10 x 16.0m2 = 3,336 N (340 kgf uplift/drag)

 


3. Torsional Load on the Drive Shafts

Because the solar panels act as a large lever arm (r = 0.88m) mounted to the offset drive shafts, the wind creates a significant twisting moment (T) around the shaft axis.

 

 

Peak Dynamic Torque (Tpeak) = Fperp x r = 3,336 N x 0.88m = 2,936 N.m

 

 

Using the dual offset drive shaft layout (as proven on the Elizabeth Swann rig), this torque is shared across two parallel driven shafts running along the central deck spaceframe:

 


Torque per Shaft (Tshaft) = 2,936 N.m\2 = 1,468 N.m


Torsional Shear Stress Check (6082-T6 Aluminium Hollow Drive Shaft):

Assuming a heavy-duty 76mm OD (3") x 6mm wall thickness 6082-T6 aluminium structural torque tube:

• Polar Moment of Inertia (J):  

• Peak Torsional Shear Stress :

 

 

• Safety Factor (SF): 6082-T6 shear yield strength is = 150MPa

 

 

(Sufficient reserve for 30-knot gusts)

4. Shaft Deflection & Angular Twist

Across the 9.2m wing span supported by intermediate pillow-block bearings spaced every 2.3m:

• Angular Twist (theta_twist) :

 

 

 

 

 


Key Structural Recommendation:

An angular twist of 6.3 degrees under maximum 30-knot gusts is acceptable, but to prevent panel racking (glass cracking), intermediate support bearings should be placed every 2.0 to 2.3 meters along the deck edge, and torsional dampers should be installed at the reduction gearbox output.

5. Storm-Furl / Flat-Stow Mode (0° Tilt)

 

When gusts exceed 25–30 knots, CoastVax’s automated control system triggers the actuators to fold the wings flat over the deck (0° tilt) or completely folded-over double-deck mode:

• At 0° Stow Angle, the Drag Coefficient (Cd) drops to 0.12–0.18.

• Uplift/Drag Force at 30 knots (Flat Stow): Drops from 3,336N down to ~410 N (~42 kgf).

• Torsional Shaft Torque: Drops from $2,936 N.m down to < 150 N·m, placing virtually zero fatigue stress on the hydraulic/gearbox drives.

 

 

 

 

 

 

 

 

 

 

 

 


....

 

 

 

 


....

 

 


.....

 

 

 

TESTING - Chris Close (Project Director 2015-2017) is seen here watching the SeaVax proof of concept boat filter plastic particles from water in our test tank facilities, in this case small polystyrene pieces were scattered on the surface and recovered using twin hydrocyclonic chambers to trap the plastic, while clean water was returned to the tank. Simple, and it worked. We designed and built the craft in house.

 

 

 

 

 

THE UNITED NATIONS UNEP - Could SeaVax be a part solution for UN goals?

CAPEX AND OPEX - What level of G20 investment is required?

GHOST FISHING GEAR - Drowning fish, mammals and reptiles, and animal poisoning

HEALTHIER OCEANS & BLUE GROWTH - What are the health benefits?

INVESTABILITY - Can SeaVax 2.0 AI be a commercial success?

WHERE DOES AI COME IN? - Will artificial intelligence make a difference?

WHAT IS THE MARKET VALUE OF OCEAN PLASTIC? - Is it worth fishing for marine plastic? 

CERTIFICATION - How will the ocean plastic be verified for credits?

WORLD BANK, IMF & UNEP - Are there any match funding opportunities?

CIRCULAR (PLASTIC) ECONOMY - FISHING GROUNDS

PATENT APPLICATION - GB2622325.5 23rd September 2026

PATENT ABSTRACT - DESCRIPTION - CLAIMS - ACCELERATION

SARGASSUM CHAIN - The 5,500 mile bloom, 33 million ton Atlantic belt?

SARGASSUM $VALUE - Where is the dollar value in recovered treated brown sea weed?

THE CARIBBEAN - Gulf of Mexico, Cancún, Tulum - Barbados, Saint Lucia, Martinique, Guadeloupe, 

                              Dominican Republic & Puerto Rico

 

COASTVAX (CVAX) - Ballpark budget 10-14 meter coastal prototype - self build concept

CVAX SHIPYARD - Commercial construction estimates 5083 and 6082 alloys

CVAX SOLAR POWER - Wing panels stressing and hydraulic gearbox calculations for 30 knot winds

CVAX UK - Blue channels for coastal operations: Bristol, Lyme Bay, Celtic Sea, Dover Straits, Irish Sea

CVAX MEDITERRANEAN - Blue channels (Libya, Egypt, Cyprus, Aegian, Adriatic, Alboran, Balearic, seas

CVAX GULF OF MEXICO - Yucatan Channel, Campeche Bay, Florida Straits, Texas Islands

CVAX CARIBBEAN - Colombia, Costa Rica, Belize, Haiti, Honduras, Jamaica, Nicaragua, Panama, Venezuela

 

 

 

 

The SeaVax proof of concept boat during open water trials

 

 

OPEN WATER - SeaVax is seen here during open water floatation trials. Please note that this is a small (proof of concept) version of any ocean or river floating dustcart that we hope will be tested on the south coast of England as the project progresses. SeaVax is a selective filtration machine that can be configured to target solid plastics and particles. The machine could also be used in oil spill emergencies, or as a selective fishing vessel. The platform could thus be useful in many ways.

 

 

 

 

 

 

 

 

 

 

 

There are 5 swirling ocean garbage patches, filled with marine litter/plastic, called gyres. That said, we will not be looking any further than UK and Mediterranean littoral coastlines and rivers with any CoastVax test rig - if we get that far. As we say, the idea is the easy part. Funding, is another matter. That is in the hands of the gods and the will of the people.

 

 

LINKS & REFERENCE

 

https://www.

 

 

 

Humpback wales are dying from plastic pollution

 

 

MARINE LIFE - This humpback whale is one example of a magnificent animal that is at the mercy of human activity. Humans are for the most part unaware of the harm their fast-lane lifestyles are causing. We aim to change that by doing all we can to promote ocean literacy.

 

 

 

 

 

 

COASTAL 10-14 METER COASTAL (RIVERVAX) PROTOTYPE - BALLPARK CONSTRUCTION ESTIMATES - CROWD, EU HORIZON, LOTTERY FUNDING